Table of Contents
Advertisement
To remove a blade handle, complete the following steps.
1. Before you begin, read "Safety" on page v and "Installation guidelines" on
page 47.
2. If the blade server is installed in a BladeCenter unit, remove it (see "Removing
the blade server from the BladeCenter unit" on page 49 for instructions).
3. Carefully lay the blade server on a flat, static-protective surface, with the cover
side down.
4. Locate the blade handle that you will be removing.
5. Locate the screw that attaches the blade handle to the blade server.
6. Remove the screw from the blade handle and save the screw in a safe place. It
is recommended to use the same screw when installing a blade handle.
7. If you are instructed to return the blade handle, follow all packaging
instructions, and use any packaging materials for shipping that are supplied to
you.
Installing a blade handle
Use these instructions for information about how install a blade handle.
To install a blade handle, complete the following steps:
Chapter 5. Removing and replacing blade server components
57
Advertisement
Table of Contents
