Table of Contents
Advertisement
3.3
Configuration system
The MPS2 and MPS2+ FPGA Prototyping Boards provide hardware infrastructure to enable board
configuration during powerup or reset.
The following diagram shows the board configuration system.
MPS2/MPS2+ FPGA Prototyping Board
Configuration
EEPROM
USB 2.0
User LEDs 1-8
User DIP switches 1-8
ON/OFF/Soft RESET push button
Hardware RESET push button
Configuration port connected to an external workstation
If you connect an external workstation to the MCC USB 2.0 Full Speed port, you can access the
configuration memory in the microSD card. You can then edit and copy configuration files and software
images to the SD card.
Related information
2.5 USB 2.0 Full Speed interface on page 2-29
3.6.2
config.txt
3.6.3 Contents of the MB directory on page 3-57
3.6.4 Contents of the SOFTWARE directory on page 3-58
3.6.1 Overview of configuration files and microSD card directory structure on page 3-56
100112_0200_09_en
microSD card
(USBMSD)
MCC
generic board configuration file on page 3-57
Copyright © 2013–2016, 2018–2020 Arm Limited or its affiliates. All
rights reserved.
Non-Confidential
Configuration
FPGA
DONE LED
Figure 3-1 Configuration system
3 Configuration
3.3 Configuration system
USERLED0
USERLED1
PB0
PB1
3-52
Advertisement
Table of Contents
