Clcd Connector - ARM MPS2 Technical Reference Manual

5.3

CLCD connector

The MPS2 and MPS2+ FPGA Prototyping Boards provide a female IDC connector that supports CLCD.
The following figure shows the CLCD connector.
A mark on the board indicates pin 1.
The following table shows the pin mapping for the CLCD connector J9.
Pins 1, 2, 5, 31, and 32 have 10k pullup resistors to 3V.
Related information
2.8 VGA and CLCD interfaces on page 2-32
1.3 Location of components on the MPS2 FPGA Prototyping Board on page 1-17
1.4 Location of components on the MPS2+ FPGA Prototyping Board on page 1-19
100112_0200_09_en
Note
Note
Copyright © 2013–2016, 2018–2020 Arm Limited or its affiliates. All
rights reserved.
Non-Confidential
34
33
Figure 5-7 CLCD connector
Table 5-8 CLCD connector, J9, signal list
Pin Signal Pin Signal
1 CLCD_T_SCL 2
3 CLCD_CS 4
5 CLCD_WR_SCL 6
7 CLCD_RESET 8
9 CLCD_PD2 10
11 CLCD_PD4 12
13 NC 14
15 NC 16
17 NC 18
19 NC 20
21 NC 22
23 NC 24
25 CLCD_BL_CTRL 26
27 3V 28
29 GND 30
31 CLCD_SDO 32
33 CLCD_T_CS 34
5 Signal Descriptions
5.3 CLCD connector
2
1
CLCD_T_SDA
CLCD_RS
CLCD_RD
CLCD_PD1
CLCD_PD3
CLCD_PD5
NC
NC
NC
NC
NC
GND
3V
GND
3V
CLCD_SDI
CLCD_T_SCK
5-82