Table of Contents
Advertisement
5.10
12V power connector
The MPS2 and MPS2+ FPGA Prototyping Boards each provide a Thru-hole DC power jack for
connecting external power to the board.
Connect the external mains power supply unit, which Arm supplies, to the power jack.
Alternatively, you can connect an external 12V, +/- 10%, power supply to the power jack to supply
power to the board.
The center pin is the positive side of the power supply.
Related information
2.14 Power on page 2-42
1.3 Location of components on the MPS2 FPGA Prototyping Board on page 1-17
1.4 Location of components on the MPS2+ FPGA Prototyping Board on page 1-19
100112_0200_09_en
Note
Copyright © 2013–2016, 2018–2020 Arm Limited or its affiliates. All
rights reserved.
Non-Confidential
5 Signal Descriptions
5.10 12V power connector
5-89
Advertisement
Table of Contents
