Usb 2.0 Connector - ARM MPS2 Technical Reference Manual

5.4

USB 2.0 connector

The MPS2 and MPS2+ FPGA Prototyping Boards provide one USB 2.0 mini-B connector that provides
a USB 2.0 Full Speed port. This port supports configuration file editing in the microSD, virtual UART
access to the FPGA, and CMSIS-DAP FPGA debug.
The following figure shows the USB 2.0 mini-B connector.
The following table shows the pin mapping for the USB 2.0 mini-B connector J14.
• The GND_EARTH connection is the casing of the mini-B connector.
Related information
2.5 USB 2.0 Full Speed interface on page 2-29
1.3 Location of components on the MPS2 FPGA Prototyping Board on page 1-17
1.4 Location of components on the MPS2+ FPGA Prototyping Board on page 1-19
3.2 Remote USB operation on page 3-51
100112_0200_09_en
Note
Copyright © 2013–2016, 2018–2020 Arm Limited or its affiliates. All
rights reserved.
Non-Confidential
Figure 5-8 USB 2.0 mini-B connector
Table 5-9 USB 2.0 mini-B connector, J14, signal list
Pin Signal
1 MSD5V
3 MSD_DPRAW 4
5 GND
5 Signal Descriptions
5.4 USB 2.0 connector
Pin 5 Pin 1
Pin Signal
2 MSD_DMRAW
MSD_ID
6 GND_EARTH
5-83