Cutting The Rtla30 Scale And Fastrack Carrier - Renishaw RESOLUTE DRIVE-CLiQ Installation Manual

Cutting the RTLA30 scale and FASTRACK carrier

CAUTION: During handling or installation of FASTRACK, suitable gloves should be worn to protect against injury from sharp edges.
If required cut the FASTRACK carrier and RTLA30 scale to length (separately) using the guillotine or the shears after referring to the installation drawing. Refer to the
installation drawing' on page 61.
Using the guillotine
The guillotine should be held securely in place, using a suitable vice or clamping method.
Once secured, feed the FASTRACK or the scale through the guillotine as shown, and place the guillotine press block down onto the FASTRACK /scale.
NOTE: Ensure the block is in the correct orientation (as shown below).
Whilst holding the block in place, in a smooth motion, pull down the lever to cut through the FASTRACK /scale.
Guillotine press block orientation when cutting the FASTRACK carrier
Guillotine press block
CAUTION: Do not cut
FASTRACK in these areas
Original instructions
Guillotine press block orientation when cutting the RTLA30 scale
Guillotine press block
'RTLA30/FASTRACK scale system
www.renishaw.com 63