Mounting the REXA30 ring
•
Clean the mounting face on the lower side of the REXA (see
page 19).
•
Clean the mating surface on the mounting shaft (see
•
Place the REXA onto the mounting shaft, then insert four off M5 screws with flat washers into
the four screw holes by the fiducial marks.
IMPORTANT: Do not tighten the screws at this point; simply engage the threads ensuring
that the heads do not touch the ring.
•
The recommended thread engagement is 10 mm.
NOTES:
•
Do not lubricate screws.
•
Do not use a locking compound.
Original instructions
'Storage and handling'
on
'Storage and handling'
on page 19).
Dimple or slot indicates
fiducial mark
www.renishaw.com
43