Management; Lldp; Figure 4.171 Management > Lldp > Lldp System Settings; Figure 4.172 Management > Lldp > Lldp System Settings - Advantech EKI-7712 Series User Manual

4.9

Management

4.9.1

LLDP

LLDP is a one-way protocol without request/response sequences. Information is
advertised by stations implementing the transmit function, and is received and pro-
cessed by stations implementing the receive function.
4.9.1.1 LLDP System Settings
The LLDP System Settings allows you to configure the status (enabled or disabled)
for the protocol, set the interval for frame transmission, set the hold time multiplier
and the re-initialization delay.
To access this page, click Management > LLDP > LLDP System Settings.
Figure 4.171 Management > LLDP > LLDP System Settings
The following table describes the items in the previous figure.
Item
Enabled
LLDP PDU Disable
Action
Transmission Interval Select the interval at which frames are transmitted. The default is 30
Holdtime Multiplier
Reinitialization Delay Select the delay length before re-initialization.
Transmit Delay
Apply
To access this page, click Management > LLDP > LLDP System Settings.
The following figure displays the LLDP Global Config settings.
Figure 4.172 Management > LLDP > LLDP System Settings
EKI-7720 Series User Manual
Description
Click Enabled or Disabled to set the Global Settings state.
Click to select the LLDP PDU handling action when LLDP is globally
disabled. Options include: Filtered, Bridged, or Flooded.
seconds, and the valid range is 5 to 32768 seconds.
Select the multiplier on the transmit interval to assign to TTL.
Select the delay after an LLDP frame is sent.
Click Apply to save the values and update the screen.
115