Table of Contents
Advertisement
Table 77 Advanced Application > Link Aggregation > Link Aggregation Setting (continued)
LABEL
Active
Criteria
Slot (Stacking
mode)
Port
(Standalone or
stacking mode)
Group
Apply
Cancel
15.5 Link Aggregation Control Protocol
Click in the Advanced Application > Link Aggregation > Link Aggregation Setting > LACP to
display the screen shown next. See
aggregation.
Chapter 15 Link Aggregation
DESCRIPTION
Select this option to activate a trunk group.
Select the outgoing traffic distribution type. Packets from the same source and/or to the
same destination are sent over the same link within the trunk. By default, the Switch uses
the src-dst-mac distribution type. If the Switch is behind a router, the packet's destination
or source MAC address will be changed. In this case, set the Switch to distribute traffic
based on its IP address to make sure port trunking can work properly.
Select src-mac to distribute traffic based on the packet's source MAC address.
Select dst-mac to distribute traffic based on the packet's destination MAC address.
Select src-dst-mac to distribute traffic based on a combination of the packet's source and
destination MAC addresses.
Select src-ip to distribute traffic based on the packet's source IP address.
Select dst-ip to distribute traffic based on the packet's destination IP address.
Select src-dst-ip to distribute traffic based on a combination of the packet's source and
destination IP addresses.
This field appears only in stacking mode. Click the drop-down list to choose the slot number
of the Switch in a stack.
This field displays the port number. In stacking mode, the first box field is the slot ID and
the second field is the port number.
Select the trunk group to which a port belongs.
Note: When you enable the port security feature on the Switch and configure port security
settings for a port, you cannot include the port in an active trunk group.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Section 15.2 on page 175
GS3700/XGS3700 Series User's Guide
for more information on dynamic link
180
Advertisement
Table of Contents
