Port Utilization - ZyXEL Communications XS1930-12F User Manual

Table 191 Management > Port Status > DDMI > DDMI Details (continued)
LABEL
Current
High Alarm
Threshold
High Warn
Threshold
Low Warn
Threshold
Low Alarm
Threshold

50.2.4 Port Utilization

This screen displays the percentage of actual transmitted or received frames on a port as a percentage
of the Link speed. To view port utilization, click Management > Port Status > Port Utilization to see the
following screen. Alternatively, click Status from any Web Configurator screen and then the Port Status
link in the Quick Links section of the Status screen to display the Port Status screen and then click the
Utilization link tab.
Figure 266 Management > Port Status > Utilization
The following table describes the labels in this screen.
Table 192 Management > Port Status > Utilization
LABEL
Port
Link
Tx kB/s
Tx Utilization%
Rx KB/s
Rx Utilization%
Chapter 50 Port Status
DESCRIPTION
This displays the current status for each monitored DDMI parameter.
This displays the high value alarm threshold for each monitored DDMI parameter. An alarm
signal is reported to the Switch if the monitored DDMI parameter reaches this value.
This displays the high value warning threshold for each monitored DDMI parameter. A warning
signal is reported to the Switch if the monitored DDMI parameter reaches this value.
This displays the low value warning threshold for each monitored DDMI parameter. A warning
signal is reported to the Switch if the monitored DDMI parameter reaches this value.
This displays the low value alarm threshold for each monitored DDMI parameter. An alarm
signal is reported to the Switch if the monitored DDMI parameter reaches this value.
DESCRIPTION
This identifies the Ethernet port.
This field displays the speed (such as 100M for 100 Mbps, 1000M for 1000 Mbps, or 10G for 10 Gbps)
and the duplex (F for full duplex). This field displays Down if the port is not connected to any
device.
This field shows the transmission speed of data sent on this port in kilobytes per second.
This field shows the percentage of actual transmitted frames on this port as a percentage of the
Link speed.
This field shows the transmission speed of data received on this port in kilobytes per second.
This field shows the percentage of actual received frames on this port as a percentage of the Link
speed.
XS1930 Series User's Guide
363