Table of Contents
Advertisement
TM
Dante
Device Setup
The iAM1-SUM default Dante Device Name is "Wohler- ..." followed by the last 6
digits of the Dante port MAC address, as shown in Figure B-2. This name can be
changed by the Dante Controller to appear that way on the network, but that will
not change the iAM-SUM unit name appearing on GUI pages and iAM-SUM Remote
Metering or Discovery pages.
Figure B–2: iAM-SUM Name
During initial setup, you may want to manually change the iAM unit Name in the
System Setup
page to match the reassigned Dante Device Name for consistency.
Refer to Figure B-3.
Figure B–3: Rename iAM
Change the iAM
AoIP Name
Other changes such as Latency settings can be made by the Dante Controller
through the Device View menus. Some changes may require remote rebooting of
Page 99
iAM-SUM
Advertisement
Table of Contents
