Table of Contents
Advertisement
the AES input. Touch the On - Off switch to change the termination setting.
3. Source Knob Selection: This setting determines the function of the Source
knob on the front panel. It may be set as follows, depending upon your
needs:
a. Source Select: The Source knob will select the input source to be
monitored.
b. All Presets: The Source knob will select between any Presets present
in the unit.
c. Favorite Presets: The Source knob will select between any of the
Favorite Presets present in the unit.
d. No Operation: The Source knob will perform none of the above listed
selection operations. If the Source knob is set to No Operation and
is turned, the Audio Meters screen will display
seconds at the top center, as a reminder.
Note: Regardless of the Source Knob Selection, the Source knob is
used to select clusters when in the Loudness Meter Screen.
Touch Cancel & Exit or Save & Exit to exit this menu.
Meter Scales
Touching the Meter Scales button on the Unit Settings Menu displays the Meter
Scales screen as shown in Figure 2-24. The controls on this screen select the scale
standards as well as the ballistics that will be applied to the audio meters.
The controls function as follows:
1. Scale: This meter scales standard to be used when displaying audio levels. A
choice of seven scales is available. Touch the left or right arrows to select
the scale. A representation of the chosen scale will be shown at the right.
The possible scales that can be selected are shown in Figure 2-25.
iAM-SUM
Figure 2-24: Meter Scales Screen
Page 34
for 3
Advertisement
Table of Contents
