Table of Contents
Advertisement
Channel Meter Screen
Audio meters, as well as other indicators are displayed on the wide touchscreen
LCD display in Clusters which can be set up as single channels or stereo pairs, as
shown in Figure 2-8.
1. Cluster Labels: The name or input source of each Cluster is shown. If
this designation is dark, the Cluster is not included in the mix. However,
if the block containing the name is bright green, then the Cluster is part of
the mix. The text of the Cluster Label may be set using the Web GUI.
Refer to Chapter 4.
2. Cluster Number: Above the level meters are the Cluster Numbers. They
indicate the arbitrary sequential numbers of each Cluster in the selected
source. They may be set using the Web GUI. Refer to Chapter 4.
3. Speaker Assignment: The destination of each channel is shown:
4. Level Meters: A Level Meter is shown for each channel.
5. Trim Dials: At the bottom of each channel pair
is the round Trim Dial indicator. Its rotational
position shows the whether the Cluster has been
trimmed and relatively how much:
adjustment range is -60dB to +12dB, and the
dot indicates where 0dB is located in the range.
6. Channel Trim: The channel gain of a particular Cluster can be changed
dynamically. When a Cluster can be adjusted, the Trim Dial will highlight
in purple:
Dial shows the adjustment.
Note: To undo all Cluster trims and reset them to the default value in the
iAM-SUM
Figure 2-8: Audio Level Meter Screen
Indicates the channel will be monitored from the left speaker.
Indicates the channel will be monitored from the right speaker.
Indicates the channel will be monitored from both speakers.
The rotational position of the indicator within the Trim
The
Page 19
0 dB
Position
Advertisement
Table of Contents
