Table of Contents
Advertisement
Updating Multiple Units Remotely
Use the following steps to update one or more iAM-SUM units remotely by
transferring the software from a previously updated iAM-SUM:
1. If any of the iAM-SUM units that you intend to update remotely may be in
use, contact the people using them and let them know what you will be
doing. The iAM-SUM units being updated will be temporarily out of service.
2. Use the Wohler Web GUI to connect to an iAM-SUM already containing the
latest update. This will be referred to as the Master Unit. Navigate to the
System | System Update | Remote System Update menu. The screen
shown in Figure A-12 will appear and the Web GUI will scan the network for
any active iAM-SUM units.
Note: The scanning process will take 2 minutes. Progress is shown on the
screen. If for some reason you would like to stop the scan prematurely, click the
Stop Scan button.
Important:
Master Unit at a time, to avoid problems. Although you may be updating
multiple units at the same time, never attempt this process from more than one
Master Unit.
3. When the scanning is complete, a list of found iAM-SUM units will be shown
as in Figure A-13. Click either Select All or click only the Target units that
you want to update.
iAM-SUM
Figure A-12 – Scanning for iAM-SUM Units
run the scanning or updating process from
Do not
Page 94
more than one
Advertisement
Table of Contents
