Table of Contents
Advertisement
AES67
The iAM-SUM Brooklyn II can be configured for AES67 operation. Refer to Figure B-
5. AES67 operation with Dante is limited to eight or less receive and transmit
channels at 48 kHz sample rates.
24 bit linear (L24) encoding and 1 msec packet time are fixed default transmit
parameters.
16 bit (L16) or 24 bit (L24) encoding and 125/250/333/100 µsec packet times can
be received.
The Device View - AES67 Config menu enables/disables AES67.
Figure B–5: AES67 Enable/Disable
Further, Dante AES67 discovery and operational protocol requires manual
assignments for static multicast transmit and receive IP addresses per Dante
protocols for discovery and IGMP network operation. Destination addresses in range
239.nnn.0.0 – 239.nnn.255.255, port 5004 o nnn can be configured using the
Dante Controller. The default is 69. The destination and receive address range must
match. Provisions for this are in Dante Controller Device View - Network
Config. Refer to Figure B-6.
Page 101
iAM-SUM
Advertisement
Table of Contents
