Table of Contents
Advertisement
7. At this point, wait for the update to complete. It may take several minutes,
but
it is critical not to disturb the iAM-SUM or the Web GUI
update process is complete. When it is complete, the iAM-SUM will restart.
Updating an iAM-SUM Remotely
Use the following steps to update the iAM-SUM software:
1. The Software Update files you downloaded earlier must be in the same
computer that is running the Web GUI. Connect to the iAM-SUM with the
Wohler Web GUI. Navigate to the System | System Update menu. Click
within the large blue dotted line rectangle at the right of the screen. A file
selection window will open, as shown in Figure A-9.
2. Click the two update files. One will have a suffix of .wx and the other will
have a suffix of .md5sum. If you make a mistake and click the wrong file(s),
click the Cancel Upload button and try again. When the files have uploaded,
the System Update button will be enabled. Click it. If there is a problem
with the files as this point one of the screens shown in Figures A-10 or A-11
will appear. In that case follow the directions on the screen to retry. If there
are no problems, the update will proceed and the screen shown in Figure A-8
will appear.
iAM-SUM
Figure A-9 – System Update Menu
Page 92
until the
Advertisement
Table of Contents
