Table of Contents
Advertisement
Factory Reset
The Factory Reset function should be used with caution. It deletes all of the
settings you have programmed into the system. It returns the system to the way it
was when received new from the factory. After using this function, you will need to
reprogram everything from the start.
Figure 4–26: Factory Reset
iAM-SUM
If you have any doubt as to whether you should perform a Factory Reset,
do not
click the Initiate Factory Reset button. Contact Wohler Technical Service for
advice.
Factory Reset will also reset your IP address to the default one. After a
Note:
Factory Reset, the IP Settings will need to be updated. The default IP address for
the unit is determined based upon the Mac address. It is 169.254.1.xx where xx is
the last octet of the management Mac address. For example, if the Mac address is
b4:ed:54:d0:04:28 then the IP address would be 169.254.1.40 (40 is the decimal
equivalent for the last octet of Mac address 28.)
Page 85
iAM-SUM
Advertisement
Table of Contents
