Table of Contents
Advertisement
Factory Reset
Touching the Factory Reset selection in the System Options menu displays the
Factory Reset screen as shown in Figure 2-34. Because of the large change this
function is about to make to the product, it asks for you for verification that you
really want to proceed.
The Factory Reset function should be used with caution. It deletes all of the
settings you have programmed into the system.
It returns the system to the way it
was when received new from the factory. After using this function, you will need to
use the Wohler Web GUI to reprogram everything from the start.
Figure 2-34: Factory Reset
Factory Reset will also reset your IP address to the default one. After a
Note:
Factory Reset, the IP Settings will need to be updated. The default IP address for
the unit is determined based upon the Mac address. It is 169.254.1.xx where xx is
the last octet of the management Mac address. For example, if the Mac address is
b4:ed:54:d0:04:28 then the IP address would be 169.254.1.40 (40 is the decimal
equivalent for the last octet of Mac address 28.)
If you have any doubt as to whether you should press Yes, press Back or No
instead, and contact Wohler Technical Service for advice. Pressing Back or No will
return you to the System Options menu.
Page 42
iAM-SUM
Advertisement
Table of Contents
