Adjust The Trim Of A Cluster; Selecting The Loudness Cluster - Wohler iAM-SUM8 User Manual

Adjust the Trim of a Cluster

Select the Cluster to be trimmed using one of the above methods. With the Trim
Dial highlighted, rotate the Channel Trim knob. Trim can be adjusted in 1 dB
steps from -60 dB to +12 dB. The relative trim level will be indicated on the Trim
Dial. Changing channel gain affects all the outputs that have "Volume Control"
enabled in the Web GUI. Refer to Chapter 4. For stereo Clusters, trim is applied to
both channels. To end the adjustment, remove the Solo using one of the above
methods.
Note: To undo all Cluster trims and reset them to the default value in the Preset,
press and hold the Channel Trim knob for 3 seconds.

Selecting the Loudness Cluster

To select a different Cluster to be monitored for Loudness, touch the Loudness
Reading button on the display. It will turn from green to orange. Then touch the
cluster you would like to begin analyzing for Loudness. The orange Loudness
Cluster Indicator will move to that Cluster. After 15 seconds, Loudness Reading
button will time out and turn green again.
Page 21
iAM-SUM