Table of Contents
Advertisement
ZMAN Session Sources
If the ZMAN card is to Source Flows, use the Session Sources tab. Refer to Figure
D-8. The procedure is similar to defining Sinks with the additional step to provide
the Flow a name to appear on other units in the network. Select the channel range
with a maximum of 8 channels per Flow.
ZMAN Updating
The Zman card is pre-initialized with the correct Wohler firmware load. In case of
future upgrades, use the following steps:
1. In Aneman, right click the ZMAN entry on the bottom Devices section, and
select Maintenance Mode. This brings up a web page which prompts for the
location of the Wohler provided upgrade file. The file should resemble the
following:
2. Select this file and click Open. On the web, select Update to install the
firmware.
3. After successful completion, select Reboot to reboot the ZMAN card.
4. Close the web pages and return to Aneman to set up Sources and Sinks.
iAM-SUM
Figure D-8: Session Sources Tab
firmware_1.1.7b43263_18Jun20.wohler
Page 115
Advertisement
Table of Contents
