How Do I Route Only Specific Monitored Channels To The Analog Xlr Outputs; Select? How Would I Configure Different Outputs For Source Select Choices - Wohler iAM-SUM8 User Manual

The setting shown above determines that outputs will follow the Audio Meter screen
solos & mutes for the XLR outputs because the checkbox is checked. It is not
checked for the AES outputs, so they will not be affected by the solo & mute
choices. This feature requires the optional OPT-OUTPUT-ROUTING output routing
license.
How do I route only specific monitored channels to the Analog
XLR outputs?
When the optional OPT-OUTPUT-ROUTING license is purchased, you may route
specific channels as shown below. Here Audio Meter channels 1, 3, 5, and 7 are
routed to the left analog XLR output and Audio Meter channels 2, 4, 6, and 8 are
routed to the right analog XLR output. Unchecked channels are not routed. Make
sure the Speaker Mix selection is turned off to enable this selection.
The optional Global Output Routing feature works great. But what
if we don't want to create any Presets and want to monitor audio
only using Source Select? How would I configure different outputs
for Source Select choices?
Use the Global Output Routing settings to determine how the outputs are
configured for source select options.
The Global Output Routing feature allows channels to be routed or combined and
routed to various destinations. For example, channels 1 to 8 can be routed to AES
outputs:
Page 74
iAM-SUM