Typical Questions Regarding Output Routing; What Signal Outputs Can Be Controlled Using The Output Routing Feature; How Do The Outputs Behave If I Do Not Purchase Opt-Output-Routing License; What Is The Difference Between Global Output Routing And Output Routing In Presets - Wohler iAM-SUM8 User Manual

even for outputs whether they are in Speaker Mix or Free Mix modes.
4. Volume Control: This setting determines whether each output pair is
adjusted by the Volume Control knob. Speaker/Headphone outputs are
always affected by the volume control knob, as are any outputs that are in
Speaker Mix mode.

Typical Questions Regarding Output Routing

The questions and thoughts in this section are commonly asked by people when
setting up the licensed Output Routing capability.
What signal outputs can be controlled using the Output Routing
feature?
All the outputs on the iAM-SUM can be controlled using the Output Routing feature.
This includes – Internal Speakers, Analog XLR outputs, all 4 pairs of AES outputs on
HD-15, and AoIP Pair 9 and Pair 10.
How do the outputs behave if I do not purchase OPT-OUTPUT-
ROUTING license?
If Output routing license is not purchased, the outputs are configured as follows:
1. Speakers: All monitored channels are always available on the internal
speakers. The left and right speaker assignment is determined by the
Speaker Assignment. Audio on the speakers is controlled by the Volume
and Balance knobs and is muted whenever a headphone is inserted into the
Headphone jack.
2. Analog XLRs: These outputs follow the same configuration as the internal
speakers. They are controlled by the Volume and Balance knobs and are
muted whenever a headphone is inserted into the Headphone jack. These
outputs also follow the solo/mute selections on the Audio Meter screen.
3. AES Pairs 1 through 4: The first 8 channels appear on these outputs in
numeric order. They are pre-fade, so they are unaffected by the Volume and
Balance knobs or headphone insertion. They are also unaffected by the
solo/mute selections on the Audio Meter screen.
4. AoIP Pairs 9 and 10: These outputs follow the same configuration as the
internal speakers. They are controlled by the Volume and Balance knobs
and are muted whenever a headphone is inserted into the Headphone jack.
These outputs also follow the solo/mute selections on the Audio Meter
screen.
What is the difference between Global Output Routing and Output
Routing in Presets?
Both are used to configure the unit outputs. Global Output Routing is applied by
default when you select a source or when creating presets and when you don't
iAM-SUM
Page 72