Chapter 4: Using The Iam-Mix Web Gui; Web Browser / Control Device; First Time- Ip Assignments - Wohler iAM-MIX Series User Manual

CHAPTER 4: Using the iAM-MIX Web
The IAM-MIX Web GUI allows you to customize the monitor's configuration to suit
your needs. The default presets configure each source's channels in consecutive
fashion. The following setup steps are not necessary to use the iAM-MIX in the
default configuration.

Web Browser / Control Device

Any web browser application running on any networked device such as desktop or
laptop computer, tablet or smart phone can be used with the iAM-MIX Web GUI.
Tablets would need to be linked to a copper LAN through a Wi-Fi adapter if the
tablet has no network connector.
Phones are not recommended due to their smaller screen size that will require more
scrolling.
The Chrome ®

First Time- IP Assignments

The iAM-MIX can operate with a static (fixed) or dynamic (DHCP) IPv4 address. The
address will be 172.27.2.2 when received from the factory or when reset at the
front panel. The iAM-MIX address will need to be changed to some other address to
be compatible with the customer's network address assignments. Go to iAM-MIX
Network Setup, immediately after this host setup is done, to change the unit's
address.
The surest way to do this, free of possible network conflicts, is to establish a static
peer-to-peer connection between the setup computer and the iAM-MIX. A
10/100/1000 MHz Ethernet switch may be used in between, but is not required.
Figure 4-1 below shows an example of suitable address settings for the host
computer in a Windows 7 control panel.
GUI
web browser is recommended for speed and compatibility.
Figure 4–1 Host IP Settings
Page
15