Table of Contents
Advertisement
Network Setup
Make network IP Address changes for the local iAM-SUM Management (MGMT)
Port here.
iAM-SUM
The procedure for changing the IP Address information is as follows:
1. Use DHCP? Check this box if your network has a DHCP server and you want
to use dynamic addressing. Otherwise, you must enter static IP address
entries in the four fields which follow.
2. IP Address: Enter the network address. Leading zeroes are not required.
3. IP Mask: This should usually be 255.255.255.0 unless your network can
work across multiple subnets.
4. Gateway Address: This should usually be the same domain and subnet
address numbers as the IP Address, but with the last octet being .1.
5. DNS-nameserver: A default value is shown for reference only. DNS is not
normally required for basic static IP network configurations to work. Your IT
administrator will specify a value to work with mixed static/dynamic network
setups.
6. Apply: When you have made all of the necessary entries, press Apply to
apply the changes.
7. Reset: If you should start to make changes and then change your mind
about making them, press Reset to return the settings back to where they
were.
iAM-SUM
Figure 4–2: Set IP Addresses
Page 54
Advertisement
Table of Contents
