Table of Contents
Advertisement
a. Manual: Touch the Manual button to enable Manual Mode. This allows
you to measure the loudness of a specific program or segment of a
program, such as a commercial. In this mode, the Start and Stop
button on the Loudness Meter screen can be manually used to begin
and end a loudness measurement interval. The reading for that
interval is then held on the Loudness Meter.
b. Continuous: Touch the Continuous button to enable Continuous
Mode. In this mode, loudness readings are continually made. The Stop
button on the Loudness Meter screen is not active.
Note: Further and more detailed descriptions of all of the above Loudness terms
may be found in the ITU-R BS.1770-3 loudness standard.
When you have finished making the settings click Apply to save them or click
Cancel to discard them.
Front Panel Configuration Tab
To prevent accidental or unauthorized changing of critical settings in the local
product menus, it is possible to restrict access. The Front Panel Configuration Tab
entry screen is shown in Figure 4-10. This provides an entryway to the Front Panel
Configuration Tab shown in Figure 4-12. To proceed, you must enter the correct
Passcode. If no Passcode has been set, the default Passcode is 0-0-0-0.
Figure 4-10: Front Panel Configuration Tab – Passcode Entry
If an incorrect Passcode is entered, the screen shown in Figure 4-11 appears. Click
the Continue button to try again. If you have forgotten the Passcode, this can be
remedied by performing a Factory Reset. Unfortunately, this will also erase all of
the menu settings. You may also contact Wohler Technical Service for help.
iAM-SUM
Page 62
Advertisement
Table of Contents
