Preset / Config Menu
Operators can select another preset or check machine status by pressing the red
PRESET / CONFIG button on the front panel. It is recessed to prevent accidental
activation. If accidentally pressed, pressing "EXIT MENU" or any button below a
non-illuminated display will exit the menu and return to normal monitor operation
unchanged.
Preset Selection
Pressing control strip (knob) button #1, directly below "SET PRESET" displayed will
display all the available presets by name. The current preset will be highlighted in
reverse video, press it to exit the menu with no changes. Press any other button to
select that preset and exit the menu.
Current Version
Pressing "VERSION AND SN" (#2) shows the software rev and serial number.
Current IP Address
Pressing "SHOW IP ADDR" (#3) displays the IP Address currently set.
Reset IP Address
Pressing "RESET IP ADDR" (#4) changes the unit's network address to factory
default (172.27.2.2). A confirmation message will ask if you are sure. Answer "NO"
if not sure.
Get USB Configs
Pressing "GET USB CONFIGS" (#5) allows the unit to load presets saved from
another iAM-MIX. Press "YES" to proceed, following prompts on the panel. Press
"NO" to cancel and exit the menu.
Figure 2-4 Preset / Config Menu
Page
11