3. Connect the coolant lines between the chiller and the projector.
To avoid cross-connections, the supply and return lines have specific male and female quick
connectors that connect into the projector.
a) Connect the open end of the Chiller Outlet hose to the chiller outlet port and tighten the
required worm gear clamp.
b) Attach the Chiller Outlet quick connector (male) to the projector inlet port (female).
c) Connect the open end of the Chiller Inlet hose to the chiller inlet port (at the filter) and
tighten the required worm gear clamp.
d) Attach the Chiller Inlet quick connector (female) to the projector outlet port (male).
CP4440-RGB and CP4450-RGB Installation and Setup Guide
020-103072-05 Rev. 1 (01-2023)
Copyright
©
2023 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Installing and setting up
40