5. Open the Service door on the side of the projector.
6. To adjust the convergence knobs, use the 3 mm driver included with the projector.
If adjusting by hand without using the tool, pull out the convergence adjustment knobs to
engage them.
7. Use the Convergence test pattern to assist with adjusting the horizontal and vertical lines.
CP4440-RGB and CP4450-RGB Installation and Setup Guide
020-103072-05 Rev. 1 (01-2023)
Copyright
©
2023 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Adjusting the image
83