Christie CP4440-RGB Installation And Setup Manual page 38

3. Connect the L, N, and PE harness connectors to the corresponding terminals.
4. Tighten the screws at each terminal.
5. Route the power cable through the slot provided on the terminal block cover.
To avoid pinching the power cable, make sure the cable and rubber grommet are placed inside
the cover cutout.
CP4440-RGB and CP4450-RGB Installation and Setup Guide
020-103072-05 Rev. 1 (01-2023)
Copyright © 2023 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Installing and setting up
38