Christie CP4440-RGB Installation And Setup Manual page 36

2. Connect the A, B, and PE harness connectors to the corresponding terminals.
Do not use the H1, H2, or H3 terminals.
3. Tighten the screws at each terminal.
4. Re-attach the signal terminal cover using the two cover screws.
To avoid pinching the cable, make sure the cable and rubber grommet are placed inside the
cover cutout.
5. Connect the RS-485 connector to a serial cable and into the RS-485 communication port on
the projector.
CP4440-RGB and CP4450-RGB Installation and Setup Guide
020-103072-05 Rev. 1 (01-2023)
Copyright © 2023 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Installing and setting up
36