Projector Power Modes - Christie CP4440-RGB Installation And Setup Manual

Leave the small adapter puck with the four screws installed.
8. Select a side to install the ball mount with the three button head screws.
The ball mount has hole patterns for 4-point and 3-point mounting.
9. Install the touch panel to the new ball location.
10. To turn the touch panel on, select the Power button on the top of the panel.
If the projector is not connected to AC power with breakers in the ON position, you cannot turn
the touch panel on.
To make sure the touch panel starts up successfully, the touch panel must be connected to the
projector before the projector is powered on.

Projector power modes

The CP4440-RGB and CP4450-RGB projectors track laser operation hours for the laser optical sub-
systems (LOS) and the lamp operation hours for xenon lamps.
The projector operates with the following power modes:
Mode
Standby
Standby (IMB On)
Projector on
Light source on
CP4440-RGB and CP4450-RGB Installation and Setup Guide
020-103072-05 Rev. 1 (01-2023)
Copyright © 2023 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Description
• CineLife+ electronics remain on standby with the light engine off.
• Fans, laser optical sub-systems (LOS) or xenon lamp, and thermo-electric cooler
(TEC) devices are off.
• IMB is off—IMB automation does not function.
• Fire alarm does not function.
• CineLife+ electronics and the IMB are powered on with the light engine off.
• Power is available to the optional touch panel and laser optical sub-systems
(LOS).
• Power is available to the thermo-electric cooler (TEC) devices; however, the
drivers are disabled.
• Some fans are low speed (depending on projector type).
• Pumps are off.
• Chiller is off (if applicable).
This mode is set from Service Setup > Preferences > IMB.
• CineLife+ electronics and light engine are on.
• LOS and TEC devices are off.
• Chiller is on (CP4440-RGB and CP4450-RGB projectors only).
• IMB is on.
• CineLife+ electronics and light engine are on.
• LOS and TEC devices are on.
• Fans run at full speed.
• Chiller is on (CP4440-RGB and CP4450-RGB projectors only).
Installing and setting up
34