Christie CP4440-RGB Installation And Setup Manual page 30

D IN-LINE B input plug
E 48V power supply B
F 48V power supply A
G IN-LINE A input plug
H UPS A plug
Before connecting the UPS device, ensure the projector is disconnected from power.
1. Remove the rear cover of the projector by loosening the six screws.
2. Disconnect the IN-LINE A input plug from the 12V power supply A (top left).
3. Remove the protective cap from the UPS A plug.
4. Connect the UPS A plug to the 12V power supply A.
5. Place the protective cap from the UPS A plug on the IN-LINE A input plug.
6. Repeat steps 2 to 5 for the UPS B and IN-LINE B plugs on the 12V power supply B (top right).
7. Re-install the rear panel of the projector.
8. Obtain the appropriate line cord for your region and plug the cord into the UPS device, and
then into the UPS inlet on the projector.
A UPS circuit breaker
B UPS inlet (200 - 240 VAC, 10 A)
CP4440-RGB and CP4450-RGB Installation and Setup Guide
020-103072-05 Rev. 1 (01-2023)
Copyright © 2023 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Installing and setting up
30