Christie CP4440-RGB Installation And Setup Manual page 33

A Mounting arm
B Ball joint
3. While supporting the touch panel, fit the other end of the touch panel mounting arm over the
ball joint on the rear panel of the projector.
4. Tighten the mounting arm until it fits tightly on the ball joint.
5. Connect the touch panel USB cable to the USB port on the rear of the touch panel.
6. Connect the other end of the USB cable to a USB port on the projector input panel.
When connecting the USB cable, the locking screw should be tightened using no more than 2 in-
lb of torque. Over-tightening the locking screw can damage the connector.
7. To install the touch panel on either side of the projector, uninstall the four screws securing the
ball mount and remove it.
CP4440-RGB and CP4450-RGB Installation and Setup Guide
020-103072-05 Rev. 1 (01-2023)
Copyright © 2023 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Installing and setting up
33