Projector Power Modes - Christie CP2309-RGB Installation And Setup Manual

5. Connect the touch panel harness to the touch panel:
a) Connect one end of the USB cable to the USB port on the rear of the touch panel.
b) Connect one end of the touch panel power cable to the DC IN 12V port on the rear of the
touch panel.
c) Connect one end of the VGA connector to the VGA port on the rear of the touch panel.
6. Connect the touch panel harness to the projector:
a) Connect the other end of the USB cable to a USB port on the projector communications
panel.
b) Connect the other end of the touch panel power cable to the Screen Power port on the
projector communications panel.
7. To turn on the touch panel, select the Power button on the top of the panel.
If the projector is not connected to AC power with breakers in the ON position, you cannot turn
on the touch panel.

Projector power modes

The CP2309-RGB projectors track laser operation hours for the laser optical subsystem (LOS).
The projector operates with the following power modes:
Mode
Projector on
Light source on
Standby
CP2309-RGB Installation and Setup Guide
020-103078-04 Rev. 1 (11-2023)
Copyright © 2023 Christie Digital Systems USA, Inc. All rights reserved.
If printed, please recycle this document after use.
Description
• CineLife+ electronics and light engine are on
• Laser optical subsystem (LOS) is off
• Thermo-electric cooler (TEC) devices for CP4415-RGB and CP4420-RGB are off
• Integrated Media Block (IMB) is on
• CineLife+ electronics and light engine are on
• LOS is on
• TEC devices for CP4415-RGB and CP4420-RGB are on
• Fans run at full speed
• IMB is on
• CineLife+ electronics remain on standby with the light engine off
• Fans and LOS are off
• TEC devices for CP4415-RGB and CP4420-RGB are off
• IMB is off—IMB automation does not function
Installing and setting up
24