Operating The Projector; Projector Power Modes - Christie CineLife+ CP4415-RGB User Manual

Operating the projector

Learn how to operate the projector and adjust projector settings.

Projector power modes

The CineLife+ projectors track laser operation hours for the laser optical sub-systems (LOS) and the
lamp operation hours for xenon lamps.
The projector operates with the following power modes:
Mode
Standby
Standby (IMB On)
Projector on
Light source on
CineLife+ User Guide–CP4415-RGB, CP4420-RGB, CP4435-RGB, CP4440-RGB, CP4450-RGB, CP2420-Xe, CP4420-Xe
020-103073-06 Rev. 1 (03-2022)
Copyright © 2022 Christie Digital Systems USA, Inc. All rights reserved.
Description
• CineLife+ electronics remain on standby with the light engine off.
• Fans, laser optical sub-systems (LOS) or xenon lamp, and thermo-electric cooler
(TEC) devices are off.
• IMB is off—IMB automation does not function.
• Fire alarm does not function.
• CineLife+ electronics and the IMB are powered on with the light engine off.
• Power is available to the optional touch panel and laser optical sub-systems
(LOS).
• Power is available to the thermo-electric cooler (TEC) devices; however, the
drivers are disabled.
• Some fans are low speed (depending on projector type).
• Pumps are off.
• Chiller is off (if applicable).
This mode is set from Service Setup > Preferences > IMB.
• CineLife+ electronics and light engine are on.
• LOS and TEC devices are off.
• Chiller is on (CP4440-RGB and CP4450-RGB projectors only).
• IMB is on.
• CineLife+ electronics and light engine are on.
• LOS and TEC devices are on.
• Fans run at full speed.
• Chiller is on (CP4440-RGB and CP4450-RGB projectors only).
• IMB is on.
14