6.2.1.3.
Configuring the measurement view
Only those parameters and units which are enabled in the
measurement view appear in the measurement view, the saved
measurement protocols and the protocol printouts.
> Before performing measurements set up the measurement view
in such a way, that the required parameters and units are
enabled, see Measurement view, page 45.
6.2.1.4.
Setting location and fuel
Before carrying out measurements, the measurement location and
the fuel must be correctly selected, see Address/Location, page 40
and Fuels, page 53.
6.2.2.
Flue gas
Calling up the function:
2. Select the fuel → [OK].
Performing the measurement:
-
The meas. views are displayed.
>
[Options]
-
Draft measurement zeroing
-
Draft measurement begins automatically
> Hold the draft measurement value displayed:
To achieve usable measurement results, the measurement
period of a flue gas measurement should be approx. 3 min
and the measuring instrument should display stable
measured values.
If a separate measurement of CO undiluted has not yet
been carried out, this value is calculated using the meas.
views of the flue gas probe and is updated continuously.
If CO undiluted has already been measured separately, the
value obtained is adopted.
→
Draft measurement start/stop
The draft measurement option is only available if the
measurement parameter
display.
6 Using the product
Draft
is enabled in the reading
[Drgt stop]
57