Ensure Safety - TESTO 330 Instruction Manual

2 Safety and the environment
Representation Explanation
Menu
[OK]
... | ...
"..."
2.2.

Ensure safety

> Only operate the product properly, for its intended purpose and
within the parameters specified in the technical data. Do not
use any force.
> Do not operate the instrument if there are signs of damage at
the housing, power supply or feed lines.
> Do not perform contact measurements on uninsulated, live
components.
> Do not store the product together with solvents. Do not use any
desiccants.
> Carry out only the maintenance and repair work on this
instrument that is described in the documentation. Follow the
prescribed steps exactly. Use only original spare parts from
Testo.
> Any further or additional work must only be carried out by
authorized personnel. Testo will otherwise refuse to accept
responsibility for the proper functioning of the measuring
instrument after repair and for the validity of certifications.
> Operate the instrument only in closed, dry rooms and protect it
against rain and moisture.
> Temperature data on probes/sensors only refer to the
measuring range of the sensor technology. Do not expose
handles and supply lines to temperatures in excess of 70 °C
(158 °F), if these have not be specially approved for higher
temperatures.
> The testo 330 must be checked before commissioning for any
visible damage. Do not commission the testo 330 if there are
signs of damage on the housing, mains unit or supply lines.
Electrical risk.
> The objects to be measured or the measurement environment
may also pose risks: Note the safety regulations valid in your
area when performing the measurements.
8
Elements of equipment, equipment display or
program interface.
Control keys on equipment or control buttons
in program interface.
Functions / paths within a menu.
Example entries