TESTO 330 Instruction Manual page 58

6 Using the product
- The measurement stops automatically.
- The readings are automatically displayed and saved in a record.
Option
Restart the draught measurement:
Options
> [Options]
> [Options]
is deleted.
> [Options]
> [Options]
form of a line graph.
[Options]
>
view is opened and a draught measurement can be carried out.
[Options]
>
as flue gas matrix, see below.
> [Options]
views per display page.
> [Options] → Accept measuring values from 315-3:
Ambient CO/CO2 values measured with the testo 315-3 can be
accepted by the testo 330. Data is transferred via Bluetooth® or
via the IrDA interface.
✓ A measurement was carried out with the testo 315-3.
✓ testo 330-2 is on.
✓ Data transfer at the testo 315-3 has been enabled.
-
[Options]
>
[Options]
>
during a measurement): The meas. view display menu is
opened.
58
→ Clipboard: Data are saved to the clipboard:
→ Delete clipboard: Any data saved to the clipboard
→ Save: The meas. views are saved in a record.
→ Show Graphic: The meas. views are displayed in
Draught measure
→
Flue Gas
→
→ Number of
For data transfer via Bluetooth®, the testo 315 - 3 and the
testo 330 - 2 must have this option, otherwise data is
transferred via the IrDA interface.
The testo 330 accepts the instrument-specific information
and measurement data sent from the testo 315-3. The
measurement data is displayed under
AmbCO2.
Reset to
→
Measurement
→
[Drft start]
start/stop: The measurement
Matrix: The meas. views are displayed
Lines: Change the number of meas.
Zero: The gas sensors are set to zero.
view: (This function is not available
ppm AmbCO or ppm