Removing The Rear Mounting Front Perc Module - Dell PowerEdge HS5620 Installation And Service Manual

Figure 106. Installing the adapter PERC
3. Insert the adapter PERC in the slot 1 of the system board.
Next steps
1. If removed, install the air
2. Follow the procedure listed in

Removing the rear mounting front PERC module

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the drive backplane
4. Remove the air shroud.
5. Remove the cooling fan
6. Disconnect all the cables, observe the cable routing.
Steps
1. Using a Phillips #2 screwdriver, loosen the captive screws on rear mounted front PERC module.
2. Slide the front PERC module to disengage from the connector on the drive backplane.
140 Installing and removing system components
shroud.
After working inside the
Safety instructions.
Before working inside your
cover.
cage.
system.
system.