Table of Contents
Advertisement
Steps
1. Hold the PERC card by the metal holder and align the connector to the slot on the system board.
2. Slide the PERC card into the slot till its firmly seated.
3. Install and tighten the two screws to secure the PERC card.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 66. Installing the internal PERC card
Next steps
1.
Install the expansion card
2.
Install the air
shroud.
3. Follow the procedure listed in
Removing the front mounting front PERC riser and front PERC
module
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3.
Remove air
shroud.
4.
Remove the expansion card riser
Steps
1. Loosen the two thumbscrews on the front PRERC module.
2. Pull the PERC module towards the front to the system to disconnect it from the drive backplane and lift from the system.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
riser(if removed).
After working inside your
Safety
instructions.
Before working on your system
(if installed).
system.
.
Installing and removing system components
95
Advertisement
Table of Contents
