Nortel CMTS 1000 Install Manual page 87

Nortel versalar cmts 1000 modem system: install guide
Hide thumbs Also See for CMTS 1000:
Table of Contents

Advertisement

IP Address
The IP Address is used in the management of the CMTS. It does not need
to be a globally routable IP address. Normally, it will be assigned by the
network operations group. The address will be transferred to the DHCP
server. The LCn run time component uses the IP address when the network
configuration files are updated. The IP address is transferred to the modem
when it boots.
Subnet Mask
This field allows you to enter the IP address mask to this CMTS. The value
for the mask should be provided by the network operations department.
Gateway
The entry in this field is the default gateway IP address. It is to be used by
the CMTS in this network to access all networks other than the local one.
The value should be provided by the network operations department.
Log Server
The entry in this field is the IP address of the log server. It is used by the
CMTS in this network. If the parameters read from the LCn during boot up
are not acceptable due to an invalid message digest, the LCn sends an
SNMP trap to the log server. The value should be provided by the network
operations department.
Time Server
The entry in this field is the IP address of the Time Server. It is used by the
CMTS in this network.
Upgrade Server
The entry in this field is the IP address of the Upgrade Server. It is used by
the CMTS in this network.
302693-B Rev 00
Startup Operation Procedures
3-39

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents