Replacing The Alarm Board - Nortel CallPilot 1001rp Installation And Configuration Manual

October 2002

Replacing the alarm board

Introduction
The 1001rp server alarm board and status panel are used to monitor and
indicate the server status. The basic hardware test on page 23 fails if the
board is defective or damaged. When these units are damaged, replace them
immediately.
.
Requirements
Before replacing the alarm board or panel display, gather the following
tools:
a Phillips screwdriver
an antistatic wrist strap
the replacement component(s)
Part 5: 1001rp Server Maintenance and Diagnostics
CAUTION
Risk of equipment damage
Take precautions to protect computer boards. Electrostatic
discharge (ESD) can damage boards and make them unusable.
Wear an ESD wrist strap.
Replacing basic chassis components
143