Replacing An Mpb96 Board - Nortel CallPilot 703t Installation And Configuration Manual

Replacing voice processing boards

Replacing an MPB96 board

Introduction
This section describes how to replace an MPB96 board.
You will need to replace an MPB96 board:
if the board becomes faulty
when the PCI firmware needs to be updated, and the board must be sent
back to the factory
.
Requirements
MPB96 boards (NTRH40AA)
DS30X cable (NTRH2014)
The diagram on the following page shows the DS30X cable for the
MPB96 board:
254
CAUTION
Risk of electrical damage
Wear an antistatic ESD wrist strap when handling cards or
boards, or when working inside the server.
Do not touch the components or gold-edge connectors of
cards or boards.
Place the board on an antistatic surface until you are ready
to install it.
Standard 1.0
CallPilot