Accurately Adjusting The Settings For Cutting With Crop Marks; Aligning The Positions Of Cutting With Crop Marks Manually - Roland TrueVIS MG-640 User Manual

Accurately Adjusting the Settings for Cutting
with Crop Marks

Aligning the Positions of Cutting with Crop Marks Manually

Depending on the type of media, it may not be possible to detect crop marks automatically. When crop
marks cannot be detected automatically, perform alignment manually.
The following figure is given as an example to explain how to manually set the "base point "B"" and align
points ( ).
The numbers for align points are determined with reference to the location of the base point, as shown in
the following figure. You cannot set the align points unless you specify the base point. Redoing the setting
for the base point clears any align points that have been set.
Procedure
1.
Press [◀], [▶], [▲] or [▼] to move the center of the blade to the base point "B" position.
2.
Press [FUNCTION] to display the following screen.
FUNCTION
BASE POINT
3.
Press [ENTER].
The [BASE POINT] is set. The character "B" is displayed on the screen.
W1100mm
B
4.
Press [◀], [▶], [▲], or [▼] to move the center of the blade to the "align point 1 ( )" position.
174
Optimizing the Output Quality