Step 2: Adjusting Cutting - Roland TrueVIS MG-640 User Manual

Step 2: Adjusting Cutting

For high-quality cutting, we recommend carrying out a cutting test to check the cutting quality for the
media before you perform actual cutting. Adjust the blade force depending on the cutting quality.
Procedure
1.
Close the front cover.
2.
Press [◀] while the following screen is displayed.
The cutting carriage comes out over the platen.
W 1600mm
3.
Press [◀], [▶], [▲], or [▼] to move the cutting carriage to the location where you want to carry out the
cutting test.
You can freely set the location for the cutting test.
4.
Press [FUNCTION].
5.
Press [▼] several times to display the following screen.
FUNCTION
CUT CONFIG
6.
Press [▶] to display the following screen.
CUT CONFIG
TEST CUT
7.
Press [ENTER].
The test pattern is cut.
8.
Peel off the cut shapes to verify the cutting quality.
• Two shapes are peeled off separately
You do not need to perform the setting because the blade force is appropriate.
• Two shapes are peeled off together/backing paper is also cut
Proceed to the next step to set the blade force.
9.
Press [▼] to display the following screen.
CUT CONFIG
FORCE
Preparations before Printing and Cutting Output
Printing and Cutting Method
97