Using Transparent Media - Roland TrueVIS MG-640 User Manual

Configuring Settings to Match the Properties of the Media

Using Transparent Media

Disabling Detection of the Edges of the Media
You can set up transparent media by disabling detection of the leading and trailing edges of the media.
Normally, detecting the leading and trailing edges of the media enables you to verify the presence of the
media, and the media is then ready for setup. However, since transparent media cannot be detected, set-
up will not be possible. Disabling detection of the edges of the media will prevent media skewing correc-
tion support during setup from being performed even if media skewing correction support is enabled. Use
the following procedure to determine the positions of the media during its setup.
• Roll media:2. B: Determine the positions of the media.(P. 40)
• Sheet media:1. B: Determine the positions of the media.(P. 55)
Procedure
1.
Press [MENU].
2.
Press [▼] several times to display the following screen.
MENU
SUB MENU
3.
Press [▶] to display the following screen.
SUB MENU
EDGE DETECTION
4.
Press [▶] to display the following screen.
EDGE DETECTION
ENABLE
5.
Press [▲] or [▼] to select "DISABLE".
6.
Press [ENTER] to confirm your entry.
7.
Press [MENU] to return to the original screen.
MEMO
• Default setting: "ENABLE"
• When set to "DISABLE", printing operation does not stop when the media runs out. If media runs out while
printing is in progress, immediately press [PAUSE] to stop printing. Otherwise, there is a chance that the
platen or other parts may become soiled by ink or that ink may get inside and damage the machine.
152
Optimizing the Output Quality
ENABLE