Can't Print Crop Continue; Temperature Is Too High **ﾟC; Service Call; Sheet Too Small Continue - Roland TrueVIS MG-640 User Manual

Error Messages

"CAN'T PRINT CROP CONTINUE?"

The size of the data including the crop marks is larger than the printing area of the loaded media.
To continue performing output without correcting this, press [ENTER]. At this time, the crop marks and the
portion extending beyond the printing area are not output. To stop output, stop sending data from the
computer, and then raise the loading lever. Make the printing area wider, for example, by replacing the
media with a larger piece of media, and then send the data again.
The size of the data being output is too small.
Make the horizontal-direction (scan-direction) size of the data at least 60 mm (2.37 in.). To continue per-
forming output without correcting this, press [ENTER]. At this time, the data is output without printing the
crop marks. To stop output, stop sending data from the computer, and then raise the loading lever. Change
the size of the data, and then send the data again.
"TEMPERATURE IS TOO HIGH **ﾟC"
The temperature of the location where the machine is installed has risen above the ambient tempera-
ture at which the machine can operate.
Operation cannot be continued. Turn off the sub power. The displayed temperature is the current ambient
temperature of the installation location. Bring the installed location to a temperature at which operation
is possible (15 to 32°C [59 to 90°F]), allow the machine to come to room temperature, and then turn on
the power.

"SERVICE CALL ****"

An unrecoverable error occurred or part replacement that must be performed by a service technician
is required.
Note the number displayed, and then switch off the sub power. After you switch off the power, inform your
authorized Roland DG Corporation dealer of the number that appeared on the display.

"SHEET TOO SMALL CONTINUE?"

The size of the data is larger than the printing area of the loaded media
To continue performing output without correcting this, press [ENTER]. At this time, the portion extending
beyond the printing area is not output. To stop output, stop sending data from the computer, and then
raise the loading lever. Make the printing area wider, for example, by replacing the media with a larger
piece of media, and then send the data again.

"SHEET SET ERROR SET AGAIN"

"EDGE DETECTION" is set to "ENABLE", but transparent media was loaded.
Raise the loading lever, set the "EDGE DETECTION" menu item to "DISABLE," and then reload the media.
Lower the loading lever, and then press [ENTER].
RELATED LINKS
・
P. 30Setup of Roll Media
・
P. 49Setup of Sheet Media
・
P. 152Disabling Detection of the Edges of the Media
336
Messages on the Operation Panel