System 1; System 2; System 3 - Graco Reactor 2 E-30 Operation

Advanced Display Module (ADM) Operation
System

System 1 1 1

System
Use this screen to enable pressure imbalance
alarms and deviations, set pressure imbalance
values, enable inlet sensors, and enable low
chemical alarms.
Select accessories using this screen. If the flow
meter accessory is installed, use this screen to:
• Enable ratio errors.
• Set the ratio alarm percentage.
• Enable Reactor Smart Control.
System System

System 2 2 2

Use this screen to enable Integrated Mode and
the diagnostic screen. This screen can also be
used to set the primary heater size and the
maximum drum volume.
Integrated Mode allows the Reactor 2 to control
an Integrated PowerStation, if the Integrated
PowerStation is installed. If the flow meter
accessory is installed, use this screen to set the
k-factors. K-factors are printed on the flow
meter serial number labels.
36

System 3 3 3

System System
Use this screen to select Hose Control
Mode and perform calibration. See
Hose Control Modes, page 52
on the different hose control modes.
Hose Resistance Mode can only be used
if a calibration factor is stored. See
Calibration Procedure, page
for information
56.
333023U