Graco Reactor 2 E-30 Operation page 46

Startup
9. Switch on the air compressor, air dryer, and
breathing air, if included.
10. For first startup of new system, load fluid
with feed pumps.
a. Check that all Setup
See Setup, page
b. If an agitator is used, open the agitator's
air inlet valve.
c. If you need to circulate fluid through the
system to preheat the drum supply, see
Circulation Through Reactor, page
you need to circulate material through
the heat hose to the gun manifold, see
Circulation Through Gun Manifold, page
49.
d. Turn both PRESSURE RELIEF/SPRAY valves
(SA, SB) to SPRAY
46
Setup steps are complete.
Setup
28.
48. If
.
e. Open fluid inlet valves (FV). Check for
leaks.
Cross-contamination can result
in cured material in fluid lines
which could cause serious injury
or damage equipment. To prevent
cross-contamination:
• Never Never interchange component A and Never
component B wetted parts.
• Never use solvent on one side if it
has been contaminated from the
other side.
• Always provide two grounded waste
containers to keep component A and
component B fluids separate.
f. Hold gun fluid manifold over two
grounded waste containers. Open fluid
valves A and B until clean, air-free fluid
comes from valves. Close valves.
The Fusion AP gun manifold is shown.
333023U