Spraying - Graco Reactor 2 E-30 Operation

Spraying

Spraying
Spraying Spraying
The Fusion AP gun is shown.
1. Engage gun piston safety lock and close gun
fluid inlet valves A and B.
Fusion Fusion Fusion
2. Attach gun fluid manifold. Connect gun air
line. Open air line valve.
3. Adjust the gun air regulator to desired gun
air pressure. Do not exceed the maximum
rated air pressure.
4. Set PRESSURE RELIEF/SPRAY valves (SA, SB)
to SPRAY .
5. Verify heat zones are on and temperatures
and pressures are on target, see
Home screen, page
50
Probler
Probler Probler
39.
6. Open fluid inlet valve located at each pump
inlet.
7. Press to start motor and pumps.
8. Check fluid pressure gauges (GA, GB)
to ensure proper pressure balance. If
imbalanced, reduce pressure of higher
component by slightly slightly turning PRESSURE slightly
RELIEF/SPRAY valve for that component
toward PRESSURE RELIEF/CIRCULATION
until gauges show balanced pressures.
333023U